Documentation
New here? Start with Getting started . It walks you through everything,
from checking your bed to printing many jobs in a row, and says at every step how to check that
it worked.
1. Start here
Page
For
Getting started The whole path, step by step, for beginners
FAQ Short answers: will it scratch the bed, do I need a probe, how long does it take…
Glossary What the words mean: Moonraker, probe, drop edge, push lane…
Safety What can go wrong, and what to watch before leaving the printer alone
2. Set it up
Page
For
Hardware Printing, mounting and measuring the blade; bed surfaces
Installation The install script, installing by hand, updating, removing
Removing it One line takes it back off the printer, and what it leaves
Guided setup Every screen of AUTO_EJECT_SETUP, with pictures
Slicer setup Object labels and start/end G-code for OrcaSlicer, PrusaSlicer, SuperSlicer and Cura
Web page The Auto-eject page in Mainsail: installing it and what it shows
Notifications A message on your phone when the printer needs you, or when a print is done
Remote access Watch and control the printer from your phone, from anywhere, without opening it to the internet
Spoolman With Spoolman, the queue stops before a job the spool on the printer cannot finish
Board firmware After a Klipper update, one line brings every board's firmware to Klipper's version
Printer farm Every printer on your network on one page, found by itself; the others need nothing installed
3. Use it every day
Page
For
Commands Every command and option
Integration Print end macros (DEMON, Klippain…), the job queue, the purge blob
Recovery Power cuts, restarts and emergency stops with parts on the bed
4. Fine-tune
Page
For
Configuration Every setting, what it does and its default
Strategies How the push lanes are planned
Probes Offset probes (BLTouch…) and eddy-current probes (Eddy, Beacon, Cartographer)
5. Help